Rate limiting matchings

You can ratelimit traffic through limit.

Per packet

The following example shows how to accept a maximum of 10 ICMP echo-request packets per second:

% nft add rule filter input icmp type echo-request limit rate 10/second accept

This rule matches for packets below the 10/second rate. Those packets will be accepted, therefore you will need a rule to drop packets over the ratelimit - which will not match the rule above.

You can also express things the other way around, ie.

% nft add rule filter input icmp type echo-request limit rate over 10/second drop

The 'over' specifies that will matching packets over the rate limit, those packets will be dropped.

Per byte

Since Linux kernel 4.3, you can also ratelimit per bytes:

% nft add rule filter input limit rate 10 mbytes/second accept

The rule above accepts traffic below the 10 mbytes/seconds rate.

You can also use the over option to match packets going over the rate limit, eg.

% nft add rule filter input limit rate over 10 mbytes/second drop

The rule above drops packets over the 10 MBytes per second rate.

Burst

You can also use the burst parameter to indicate the number of packets/bytes you can exceed the ratelimit:

% nft add rule filter input limit rate 10 mbytes/second burst 9000 kbytes accept

This indicates that you can exceed the ratelimit in 9000 kbytes.

You can also use it for packets:

% nft add rule filter input icmp type echo-request limit rate 10/second burst 2 packets counter accept

So you can exceed the rate in 2 packets.

You can also use the limit expression for traffic policing in a rule using the ingress hook in the new netdev family (instead of using the tc command).

The over keyword allows you to use limit intuitively in a chain with policy accept:

% nft add rule netdev filter ingress pkttype broadcast limit rate over 10/second drop